Updating suse linux 9 2

Because basic system components, such as libraries, must be exchanged when updating a base system, an update cannot be run from within a currently running Linux system. This is normally done using the CD or DVD or with a custom boot disk. Then you have the possibility to make a backup copy of the system files during the update.If you are carrying out manual modifications during the update or prefer to perform the entire update with Ya ST in text mode, follow the steps already described in detail in Section1.1. In the following dialog, either choose to update only the software already installed or to add important new software components to the system ( to start the installation of the new software from the source medium to the system hard disk. If you suspect you are running short of disk space, secure your data before updating and repartition your system.

Updating suse linux 9 2 Chatroulette cam

From this point on, however, it is your responsibility to ensure that your system remains consistent. Select components from the Ya ST package selection list according to your needs.

If you select a package essential for the overall operation of the system, Ya ST issues a warning.

Check the following issues before starting the system update.

Before you begin your update, copy the old configuration files to a separate medium just to be on the safe side.

Complete the procedure as you would a new installation. From this point on, however, it is your responsibility to ensure that your system remains consistent. Select components from the Ya ST package selection list according to your needs.

Before looking at the update of SLES, let's look at the general concept of updating and what you should expect from an update.Normally, the second column of this file should contain the device name for the encrypted partition (e.g., "/dev/hda5") or, in case you have not encrypted a whole partition but only a container file, the path to this file.However, during the update this value (device or file name) was wrongly replaced by duplicating the value of the first column: First, continue booting the Linux system by pressing ENTER when prompted to enter the password for "/dev/loop0". Then edit the file with an editor of your choice and correct it.In an update, the goal is to replace an existing set of binaries and configuration with a newer set.This is done using a set of scripted functions which examine the system and execute the update.Since Su SE is an RPM-based distribution, most of the components will be updated through the RPM process.

Tags: , ,